Tile Surface and Substrate Preparation

• All surfaces must be clean and free from dust, oil, laitance and all forms of contamination.
• Apply single layer of Bond Ace G88 to the rear side of tile, and (or) to the substrate.

Application

a) Apply cement / grout with Bondplus-TE to floor or wall using a notched trowel or butter laying.

b) The recommended bed of cement grout with Bondplus-TE should be 3-5mm thick for wall tiling and 5-8mm for floor tiling.

c) Allow cement grout with Bondplus-TE to set for minimum 7 days before performing pointing gaps grouting.

Grout Mixing Steps

1. Add in 1 pack (120gm) of Bondplus-TE into 25kg of cement (Preferred PCC), dry-mix evenly before pouring it into water.
2. Add 7.5 – 8.5 liters of clean water in the “mixing Container” to receive the pre-mixed cement.
3. Pour pre-mixed cement and Bondplus-TE slowly into the “mixing container”. (Optional) Maximun 40% of the fine sand is a allowed into mixing.
4. Stir evenly until the desired mortar paste is formed.

Recommendation / Remark

• Mixing of the fine sand is recommended if user preferred Ordinary portland cement.

Product Data Sheet